Podcasting since 2005! Listen to Latest SolderSmoke

Monday, November 30, 2020

Adam N0ZIB's Direct Conversion Transceiver


This is obviously very cool, but looking ahead I think Adam should think about adding one more mixer, changing the bias on the TX amps, and adding a mic amp.   Boom:  A Double Sideband Transceiver.  

Pete wrote: When I was in the US Navy and a particular unit did something outstanding – the Command ship would raise the Bravo Zulu Flag  for a job well. Don’t know if you can see it there in MO but I have raised the BZ flag to you. Outstanding and congratulations.

Bill and Pete: 

Just finished a DC transceiver using Arduino nano, SI5351 (my sincerest apologies, Bill), diode ring mixer and lm386 audio amp.  The transmit portion is a two-stage class AB pre-amp (from EMRFD page 2.32), which is driving an IRF510 final (biased at 2.08 volts) from Pete’s design. Output is about 5watts into a CWAZ low pass filter, based on the design from here: https://www.arrl.org/files/file/Technology/tis/info/pdf/9902044.pdf

I’m using a manual TX/RX switch which is doing multiple things. It brings the Nano A1 LOW, offsetting the transmit frequency 600 Hz for CW, grounds the audio input to prevent deafness (learned that one the hard way), and it engages a relay that switches the antenna from the receiver to the transmit, and also turns on the transmitter stages. Keying is through the first stage of the pre-amp.  

I still have some tidying up to do, and I’m not sure the LPF works so well using two component inductors instead of all toroids, but I finished it today and made my first QSO into Ontario almost 1000 miles away.  It’s been great fun! 

73,
Adam
N0ZIB
Missouri


5 comments:

  1. I am working on solid state power amp design. I have built tube amps in the past so this is a new venture for me. Is the "EMRFD page 2.32" reference referring to the Experimental Methods in RF Design book? I am looking for a good solid state design reference any recommendations?

    ReplyDelete
    Replies
    1. Yes, EMRFD is Experimental Methods in RF Design. Great book! There are some power amp designs in this book. Solid State Design for the Radio Amateur may also have amp designs. I do not have that book.

      Delete
  2. I need to give credit to Ashar Farhan also for this receiver. It is based on his DC40 receiver, minus the VFO section. He has been very helpful and supportive in my efforts to complete this rig.

    ReplyDelete

Designer: Douglas Bowman | Dimodifikasi oleh Abdul Munir Original Posting Rounders 3 Column