Wednesday, May 6, 2009

Inside a Mini-Circuits Mixer, and the Dissing of DSB

I'm not crazy about using integrated circuits, especially the really complex ones for which true understanding of how they work is impossible. The Mini-Circuits mixers are not, of course ICs, but for me they too have always had a whiff of the "black-box" about them. Thomas, OZ2CPU, pulls away the veil with this photo of the innards of an SBL-1.

I came across Thomas's very interesting web site when I was installing in my QRSS beacon rig the SBL-1 mixer sent to me by Jim, AL7RV. That poor SBL had died suddenly during testing. Thomas alerted me to the cause of death: In his caption for the picture of the innards, he notes, "I was unlucky to kill this one during my first transmit experiment. The IF input can NOT accept more than +20dBm audio level."

Joop and I have been discussing diode ring mixers, and I've been reading an article about them by Paul, NA5N. It looks to me like the designers of the SBL mixers weren't really thinking of balanced modulators when they created these things. Just look at the schematic above. In a normal receiver application, LO energy goes in from the L port, your RF goes in R, and your IF (or, in a DC receiver, your AF) comes out from the I port. But when we use these things as balanced modulators, we have to put the Audio INTO the I port. You can see how too much voltage on that port would quickly release the smoke from those little hot-carrier diodes.

The data sheets are oriented to the standard application (RF into R, LO into L, IF output at I). We are told to keep the LO level at +7dBm and that the 1 db compression point for the RF input is +1dBm. But at what level should you put the AF input to the I port if you are using this thing as a balanced modulator in a weird WSPR DSB rig? Similarly, the data sheets give SWR data across a wide frequency range for the L and R ports... but not for the I port. DSB is getting dissed!

3 comments:

  1. Hi Bill,

    "But at what level should you put the AF input to the I port if you are using this thing as a balanced modulator in a weird WSPR DSB rig?"

    It's not really critical. One just has to make sure that the voltage swing on the I port does not change the conduction state of the diode ring. The state should be determined only by the LO signal. Thus, the I port signal should be rather low, say (guessing here..) below 20% of the diode (0.7v) voltage drop, to be on the safe side. This would be 140mV peak, or -7dBm in a 50 Ohm system.

    73,
    Niels PE1OIT.

    ReplyDelete
  2. Guten Tag! Wayne Montoya . payday loans

    ReplyDelete
  3. toronto loans This website is a great I liked it to a large extent
    AAA Toronto Payday Loans 1172 Bay St #101, Toronto, ON M5S 2B4 (416) 477-2817

    ReplyDelete