Serving the worldwide community of radio-electronic homebrewers. Providing blog support to the SolderSmoke podcast: http://soldersmoke.com
Saturday, October 19, 2013
BITX Build Update #14 -- STABILITY!
Good news on the BITX. I think I have solved the low frequency oscillation problem in the power amplifier. I tried running the PA off a separate power supply -- the oscillations disappeared leading me to conclude that the feedback was taking place via the power supply lines. I put a 22 uF cap to ground from the top of the PA's RF choke. With this cap in place I can dispense with the separate supply kludge. The amp is stable.
This morning I also resolved a different stability problem. I'm using a relay for T/R switching. One set of contacts controls the DC power, the other set was supposed to disconnect the receiver input from the antenna/lowpass filter when on receive. But I had positioned the relay too far from the LP filter and RX input, so I ended up with this long piece of coax that was hanging off the PA output terminal and carrying lots of RF on transmit. Yes, this led to oscillations. I thought about repositioning the relay, but I think part of the problem is that even if optimally positioned, the long unshielded contact levers inside this relay would be radiating a lot of RF and causing stability problems. So instead I put a small reed relay very close to the PA out and RX in connections. It carries the signal to the receiver when in R mode, and disconnects the RX when in T mode, without any long coax lines or unshielded relay levers. It works.
I still have a few things to do:
-- I need to build a proper speaker amplifier so that I can dispense with the amplified computer speakers KLUDGE.
-- I need to get a 3 pole double throw switch and some crystal sockets so that I can switch crystals from the front panel. Three rocks will cover all of 17 meter phone.
-- I have to build a case for this rig. I'm thinking wood, with tin or aluminum sheeting glued to the inside (for shielding).
Our book: "SolderSmoke -- Global Adventures in Wireless Electronics" http://soldersmoke.com/book.htm Our coffee mugs, T-Shirts, bumper stickers: http://www.cafepress.com/SolderSmoke Our Book Store: http://astore.amazon.com/contracross-20
Make it look like a Philco. Hi.
ReplyDeletejohn
AD5YE