Harv's Minima

Good Evening Bill & fellow Solder-smoke friends,

 

Well, I’m following the pack. I began gathering items for the Minima Transceiver back in March 14. There had been a good bit of strong back-N-forth discussions on the Minima Blog about what works and what doesn’t work. Some circuit refinements had been agreed upon while other were left to individual preferences. So, I decided to just be silent an learn from the experts. As a result, I did several months of observing before I took the plunge. While my efforts are not nearly as aggressive as others, I decided to forge a much slower path to success.

In my own quirky way of doing things, I kitted each module, measured all the parts statically, laid out the components, and finally built & tested each assembly before going to the next.

As a result, the learning’s were great and the performance of each section equal or better than my expectations.

 

I went the Manhattan Style this time but,  I have purchased several sets of Minima PCBs to use in the future. As I see it, there is a lot more solder melting ahead.

 

Bill, building radios is NOT DEAD yet. That desire to get back to the golden days of home-brewing still lives on.

 

At the end of the Memorial Weekend, this is my current Minima progress…

 

·         Construction of all 3 Audio Stages now complete (see photos)

·         The Microphone Pre-Amp is now awaiting voice testing

·         Audio Amplifier and Final Amplifier have been tested together

·         The results of audio testing has been superb for all stages thus far

·         3 complete sets of Micro Relays have been order and I’m now awaiting their arrival

·         24 – various ferrite and powered iron cores arrived several weeks ago, these are the heart of the front-end RX/TX stages

·         100 - 20 Mhz. crystals have arrived and await characterization

·         25 - 8” Male to Male SMA Cables have arrived this weekend, will need to order 15 – 4” Male to Male SMA Cable Assemblies next

·         5 – 12” X 15” Copper Clad Boards have arrived this weekend

·         25 –J310 N-channel J RF Power FETs were ordered and arrived this weekend, these are used in the Mixer Stage

 

 

Final Audio Stage

 

 

Audio Amplifier Stage

 

 

Microphone Pre-Amplifier Stage (see microphone connector mounted at rear)

 

I’m ready to begin kitting the Side Tone Oscillator and RX/TX Relay Stages.

The largest and most intense modules are yet to be tackled.

The Bi-Directional Amplifier has 34 parts alone.  So far I have installed over 40 parts in the three modules I’ve completed…

I realize it is just a start but, I’m motivated to see this one project through to completion.

 

73’s & Happy Soldering

 

Harv -=WA3EIB=-

Albuquerque, NM.

Our book: "SolderSmoke -- Global Adventures in Wireless Electronics" http://soldersmoke.com/book.htm Our coffee mugs, T-Shirts, bumper stickers: http://www.cafepress.com/SolderSmoke Our Book Store: http://astore.amazon.com/contracross-20