David AI6WR was a patient craftsman during the build of his receiver. He diagnosed and fixed defects in the AF gain controls that he was trying to use. He hung in there, found the problem, and fixed it. Even with a challenging antenna situation his receiver is pulling in SSB signals on 40 meters.
David writes:
Thank you everyone for the suggestions! I have tried a bunch of them out, those that I could try without making a ton of changes. I have made a couple of changes and it's working much better now. It turned out that one of the major contributors to the unpredictable noise was the audio pot itself. It had poor mechanical connections between the input leads and and the internal traces that go to the resistor and wiper. They were actually wiggling around and constantly disconnecting and reconnecting randomly. I took it apart, cleaned the wiper with some rubbing alcohol, tried to get a better connection on the inputs by crimping them down and putting some solder on them, and then put it back together. Once I put that back into the circuit, it was still humming at high volume settings, but much more predictably. I also cut off the unused center tap lead on the primary side of my audio transformer. That wasn't the source of the problem, but it wasn't helping things. Finally, I put a 470u cap from the power rail to ground. That doesn't totally eliminate the hum, but along with the other changes, it reduces it enough that nearly all of the volume range is reliably usable. It will still hum if I turn it all the way up, or if there is no antenna plugged in, but I think it is working in ordinary circumstances.
Congratulations David.
------------------------------------------------------------
For more information on how you too can build the receiver:
Join the discussion - SolderSmoke Discord Server:
Documentation on Hackaday:
https://hackaday.io/project/
SolderSmoke YouTube channel:
No comments:
Post a Comment