A rough guide to how I laid out the isolation pads on my BITX 20/40 board. The copper-clad board is 8 inches x 11 inches (22 cm x 28 cm). I just cut out the pads as needed using tin shears and scrap pieces of copper clad board. Gorrilla SuperGlue is my preferred adhesive. I will put this in the appropriate file on the BITX 20 yahoo group site.
Our book: "SolderSmoke -- Global Adventures in Wireless Electronics"
http://soldersmoke.com/book.htm
Our coffee mugs, T-Shirts, bumper stickers:
http://www.cafepress.com/SolderSmoke
Our Book Store:
http://astore.amazon.com/contracross-20
Posts
No comments:
Post a Comment