Joe N90K's FB SolderSmoke Direct Conversion Receiver

Congratulations to Joe N9OK on his homebrew build of the SolderSmoke direct conversion receiver. Welcome to the Hall of Fame Joe.  

Joe makes some very nice comments on the benefits of doing this in a homebrew way:  

I've build many dozens kits over the years, esp Knight, Heath, K2, K3, and others. This was my first receiver built from scratch. It works surprisingly well and has decent sensitivity. Thanks @Bill N2CQR and Dean @Soldersmoke for creating this challenge. It was fun and non-trivial. The only stage I had issues with was the amplifier, which was too compact on v1. v2 works well.

I think Joe should hold onto that smaller version of the AF amp. I think he could get that stablized and it could become the heart of yet another FB DC RX.

Joe went the extra mile and measured the minimum discenable signal of the receiver:

 

I see no problem with Joe's measurment technique.  I think the key word here is "discernible."  Often people will focus on the RF signal that wiill produce a 3 db or 10 db increase in audio signal.  But Joe has just looked at the RF signal level that will create a discernible audio signal.  That is fine.  As Joe demonstrates, this simple DC receiver is remarkably sensitive.