Podcasting since 2005! Listen to Latest SolderSmoke

Wednesday, September 20, 2017

Can You See an Error in the Herring Aid Five Schematics?



Something caught my eye this morning.  Please take a look at the audio amplifier stages (Q3 and Q4) on the Herring Aid Five.  Can you see an error? Above is the original schematic from the 1976 QST.  Below is a 1998 update by VK1GB and KI6DS.  I see the same problem in both schematics.  Please let me know if you see an error. 






14 comments:

  1. There are missing dots on the transformer windings to say that they should be wound in the same direction. This is DC RX after all. Phasing phasing.

    ReplyDelete
  2. The first diagram is a little too blurry to fully read but the second is very clear. Anyway C14 would greatly attenuate the audio. It should be removed or made a lower value (to provide some roll-off). Also VK1GB is referred to in the blog post but VK1FB on the circuit.

    ReplyDelete
  3. This comment has been removed by the author.

    ReplyDelete
  4. This comment has been removed by the author.

    ReplyDelete
  5. That 10u C14 cap is indeed weird - that was what looked out of place to me right away as well. It is the same value as the C13 cap which brings the signal from Q3 to Q4! I would expect a much lower value if that is supposed to act as a low pass filter to take off the high frequency hiss off the signal.

    ReplyDelete
  6. Looks like the SI5351 is missing ;-)

    ReplyDelete
  7. Where is the regen control. HiHi

    ReplyDelete
  8. C14 gives a reactance of abt 16 Ohm at 1kc so C14 shorts the collector of Q3, leaving no or almost no signal to Q4 unless you like sub audio.

    ReplyDelete
  9. The value of C14 limits the audio bandwidth to about 30Hz; probably should be 0.1uf so it's just a hiss filter.

    ReplyDelete
  10. How about putting C14 and C13 in series, and not to ground, connect negative to negative so that the effective C becomes 5 uF and is non polarised?

    ReplyDelete
  11. 10 seconds flat, first (blurry) diagram, even not able to discern the value but seeing it's an electro. Confirmed in second diag. C14 needs to be perhaps (my guess, no maths) 10nF!

    ReplyDelete
  12. C14 will short out audio to gnd

    ReplyDelete

Designer: Douglas Bowman | Dimodifikasi oleh Abdul Munir Original Posting Rounders 3 Column