Opposite "sense" winding and resulting phase shift
My second attempt at building a Herring Aid 5 (the first was 1976) continues.
I thought I had discovered an error in the schematic that (I hoped) explained my failure to get this simple receiver running (scroll down for details). But Dex, ZL2DEX, in New Zealand spotted something that got QST off the hook and put all the blame back on me:
I had failed to check the rotational sense of the windings. The schematic called for 4 turns over the Radio Shack choke. So I just went ahead and wound them. I didn't pay any attention to the direction of the winding. I then hooked it up in accordance with the phasing dots in the diagram. And it didn't work. So I switched the coil connections around. And it worked. Aha! I thought! QST messed up! It wasn't my fault.
Dex brought me back to reality. He noted that I probably wound the coils with the wrong rotational sense. I confirmed this. I rewound the coil following the rotational sense of the choke. I hooked it up following the phasing dots of the schematic. This time the oscillator started right up. So the problem wasn't an incorrect drawing of the phasing dots. Instead it was my failure to remember that phasing is more than just the top or the bottom of a transformer's winding. Rotational sense is also important. That's why "phasing dots" are sometimes referred to as "sense dots."
This doesn't come up very often, because most of the toroidal transformers we make are bifilar or trifilar -- the windings are always in the correct sense because we twist the wires together before putting them on the coil. When we look at those phasing dots, we are focused on getting the proper tops of coils connected to the appropriate bottoms of other windings. We don't pay any attention to the sense of the windings. Thanks to Dex for bringing me back to my senses :-o
Grob's Basic Electronics has this definition for those phasing dots:
| " | Used on transformer windings to identify those leads having the same instantaneous polarity." |
This morning I did a little experiment to confirm all this: I took a toroidal core and wound a little transformer. Using a dual trace scope, I looked at the input and output wave forms. Sure enough, when the windings are in the same rotational sense, there is no phase shift. But when that secondary is wound in the opposite sense, you get a 180 degree phase shift. I know this is very basic, but it was fun to re-learn it and to confirm is.
But I still don't have the little receiver running. I think there are a few problems. That single BJT mixer stage needs a lot of RF (2.5 volts p-p) from the oscillator. Also, I think the 10 uH chokes that I am using are not the same as the chokes used in the original Herring Aid design. So when I build transformers on these chokes, they don't work very well.
But I will keep at it. It has been 38 years... I can wait another week or two.
Our book: "SolderSmoke -- Global Adventures in Wireless Electronics" http://soldersmoke.com/book.htm Our coffee mugs, T-Shirts, bumper stickers: http://www.cafepress.com/SolderSmoke Our Book Store: http://astore.amazon.com/contracross-20
+Yuck.JPG)
.JPG)
Posts
